Pachislo Coin Jam Prevention & Solutions
Square Plastic Brown or Black Coin Mechanism
1. Turn robot off.
2. Remove the bottom coin shield. In some cases the square brown coin mechanisms have coin shields that are hinged – just demean the coin shield. The black versions have removable coin shields. Press in on the left and right to cut off.
3. The coin alley is covered by a spring loaded place. Look closely and you can easily see the spring in the photo. Pull the spring loaded place happening – it actually moves taking place and to the upper right.
4. Clear the coin taking into consideration your finger.
If the coin is stranded in the acceptor upon the front of the robot and you can see it, attempt pulling out of the stomach. If it is lodged where you either cannot see it or cannot remove it, draw door the spring loaded area and put in choice token and shove it UP to shove dislodge the coin and draw it up through the front. Turn the robot put occurring to upon and reset if needed.
The longer metal versions perform the same habit and will with have a spring loaded front.
Preventing Coin Jams
Most coin jams are not the result of problems gone your machine but of tokens and dirt.
Almost all Pachislos yield to on .984″ tokens on your own. Although your tokens may appear to be the united size, a slighted variation in length or width may be enough to cause coin jams.
Coin mechanisms can become VERY filthy on summit of period. This caused the tokens to shape highly slowly through the coin alley and become beached in the coin mechanism or the coin chute and never drop into the hopper. Follow these steps to prevent well ahead coin jams:
1. Check for Magnetic Tokens
Before you use tokens in your machine control a magnet again them and remove any magnetic tokens. Quite a few machines will kick out or jam magnetic tokens and THEN send an error code.
For more info สล็อตออนไลน์ UFABET.
2. Check Token Sizes
Most Pashiclos by yourself receive .984″ tokens. All of your tokens may appear to be identical is size, but your machine may be selective. Anything new than.984″ will become jammed. Put the tokens in little stacks and see if any are slightly larger or thicker than the others and cut off them.
3. Clean the Tokens
Use Kaboom cleaner. Mix a tiny in a pail of hot water. Drop your tokens in and mixture them for a few minutes. Rinse them and ascetic them by now using. If you use your machine often realize this every single one six months or as a result to prevent dirt accrual in the coin mechanism, coin alley and hopper.
4. Clean the Mechanism
Removing the mechanism is easily reached. Unplug and remove it and tidy it quickly subsequent to a damp wipe, lifting the spring loaded area and cleaning there as expertly. If the metal coin alleyway is rusting use a ardent knife, screwdriver or exacto knife to remove as much rust as attainable and tidy the rust in imitation of a wipe. When you are curtains have the funds for the path a VERY SMALL squirt of silicone spray can can can, wiping off any excess.
5. Clean the Coin Chute and the Coin Acceptor
While the coin mechanism is out, tidy the outside coin acceptor where the coins enter the machine. If you have damp wipes attempt using a skinny knife to appendix a wet wipe gently into the coin acceptor from the outside of the machine and pulling it out the new side to tidy the inside. When you are satisfied spray one squirt of silicone spray into the coin acceptor, wiping off any excess silicone.