Step-by-step directions to gluing inner corners
When finishing, the main problem can be uneven walls and the consequent springs on the wallpaper. It’s also required to take into account that as soon as the walls are twisted , the joints of background canvases may diverge.
After gluing the previous one in front of the inner corner of the fabric must measure the remaining space. It is measured from the border of the glued cloth to the adjoining wall, the resulting figure is added 10-15 millimeters. When the partitions are extremely curved, the additional figure could be .
Cut a strip equal to the resultant figure, taking into consideration the allowance. The surfaces are treated with glue. Based on the kind of coat it might be just the wall or both surfaces.
The strip has been glued individually using the cut side to the wall. The wallpaper should go on the other airplane.
If the glued background is sterile, then you need to make several little cuts perpendicular to the folds.
Level or gidpola.ru slope on the adjoining wall is a vertical lineup. The distance in the corner is equal to the width of the previous cut strip, never adding developments.
The surfaces have been smeared with adhesive, and then the coat is glued to the wall using the flat side towards the line. The cut side goes onto the adjoining wall.
Protruding corner ought to be glued by analogy using an interior, however there are small gaps, which also need to be taken into consideration when working.
Measured the distance remaining from the glued background to the adjoining wall. Add 20-25 millimeters to the got figure.
A section is cut away, considering the added 20-25 millimeters.
Before gluing, the surfaces have been treated with glue.
The edge must be glued to the wallpaper fixed on the wall, the own cut “extends” to the adjacent plane. If needed, small cuts are made in the area of visiting another wallpaper, smoothed and pushed into the wall.
Draw a vertical strip onto the adjacent wall at a distance of just glued cut strip and 6-10 millimeters.
After applying the glue, the strip is placed on the wall with its flat side towards the marked line, moving over the border of this already glued strip.
The joints have been smeared with adhesive and ironed with a rollercoaster. Following that, the top layer is cut across the ruler and the 2 layers are joined together.