Disassembling a pool table can be rather easy, providing you have the right tools and manpower. The instructions listed here are for a adequate wood frame habitat pool table when a slate bed and leather slip pockets. Coin operated tables and non slate tables have exchange instructions with than disassembling.
Tools Needed: 9/16″ socket, socket wrench, Philips screwdriver. Marked sandwich baggies to place screws and bolts.
Definitions:
Rail Assembly: Contains the wooden rail, the cushion or bumpers to which the apron attaches to.
Bumpers: The rubber allocation of the rail. They are covered following felt.
Aprons: The wooded segments that exasperate to the rail assembly. Can be a remaining portion of the rail assembly or can be screwed depending as regards manufacturer of table.
Felt: The cloth that covers the playing surface and the rail bumpers. Usually it is a 75% woolen 25% nylon incorporation.
Slate: The playing surface of the pool table. Usually comes in (3) pieces. Can either be wood backed or unbacked.
Frame: The base of the pool table which the slate sits upon.
Do you know about Holzpool?
First begin off by detaching the pockets from the table itself. Usually the straps of the pockets are attached to the table itself gone either screws, staples, nails or gum.
Next using your 9/16″ socket and wrench; cut off the rail bolts (12) located underneath each rail. Place the rail bolts in a marked baggie for storage.
Take one section of the rail assembly (2 sides and peak/bottom) and flip them on peak of onto the covered bed of the pool table. Unscrew the pocket screws.
Remove pockets from rail assembly and place to side.
Place rails to the side. Some tables you will have to cut off the aprons at this narrowing.
Remove felt from slate bed. The felt is usually either glued the length of or stapled to the wood upholding of the slate. If it is stapled, surgically remove each staple deliberately, as not to rip the felt itself.
Remove the slate screws and place in marked baggie. Sometimes all the slate screws will be filled in as soon as either beeswax, Bondo or spackling putty. Carefully sever the product from each hole.
Pull the slates apart and lift each one and place to the side.These are the whole unventilated for that defense charm be cautious.
Disassemble the frame. Generally, most of the grow pass if you are just moving the table a brusque make detached all that will be required is removing the legs.
Removed the bolt from each leg. Pick table going on and remove legs and place to side.